.

×

Error

File not found

OpenCM9.04-A

Description
Features

OpenCM9.04 is an open-source controller that runs under 32bit ARM Cortex-M3.

All hardware and software are disclosed.

All Dynamixels can be controlled when using the accessory set of 485 expansion board.

Uses USB Cable (Micro-B) to download programs onto the board.

JTAG / SWD terminal can be used to run commercial developmental programs.

Various programming tools are optional.

 - ROBOTIS integrated programming software, RoboPlus

 - ROBOTIS development tool, OpenCM IDE

 - Open Source development tool, Arduino IDE

Package Components
OpenCM9.04-A 1
Instruction Manual 1
H/W Specifications
CPU STM32F103CB (ARM Cortex-M3)
Operation Voltage 5V ~ 16V
Recommended Voltage

5V for USB

7.4V for DYNAMIXEL XL Series(LB-040 3.7V x 2)

(485 Expansion Board recommended to control DYNAMIXELs requiring 12V or higher)

External I/O 26
Timer 8
Analog In(ADC) 10 (12bit)
Flash 128 Kbytes
SRAM 20 Kbytes
Clock 72Mhz
USB 1 (2.0 Full Speed)
USART 3
SPI 2
I2C(TWI) 2
Debug JTAG & SWD
TTL port(3Pin) 4 (Port Only)
External Sensor(5 Pin) 4 (ROBOTIS Sensor can be used)
Dimensions 27 mm X 66.5 mm
Weight 10g

*Connectors are not included.

Compatible Products

Dynamixel : XL-320

* All Dynamixel products can be used when OpenCM485 expansion board is used. 

 

Wireless Communication : ZIG-110A, BT-110A, BT-210, BT-410

 Infrared receiver OIR-10 (Not available when using RoboPlus

firmware)

 

External Sensor : ROBOTIS Sensors

Parts Name
Caution

Connectors are not included.

You will need to purchase the OpenCM9.04-Accessory Set and solder the product to make it into a usable, full product.

The OpenCM 485 Expansion Board, which supports TTL and RS-485, can be used to control all types of DYNAMIXELs, such as AX, MX, X and P-Series.

When using the OpenCM-9.04 to control the Dynamixel, a separate power supply must be supplied to the Dynamixel.

 

RoboPlus can be used when the board is connected to the PC via USB Downloader LN-101 or BT-210.

(PC must have Bluetooth device for Bluetooth connection)

 

ROBOTIS OpenCM IDE can be used only via Micro 5PIN USB Cable.

The RoboPlus and ROBOTIS OpenCM IDE CANNOT be used simultaneously.

The firmware must be changed depending on the software to be used.

(Please refer to the e-Manual to change the firmware)